Alchemy signal flow and Effects

Music Lesson: Understanding Signal Flow in Synthesizers

Welcome to our music lesson! Today, we will explore the signal flow of synthesizers, focusing primarily on the Alchemy synthesizer.

Overview of Signal Flow

The signal flow in Alchemy is quite similar to most other subtractive and additive synthesizers. Here's a breakdown of the components involved:

• Sources:
  • A
  • B
  • C
  • D

Alchemy allows you to have four different sources running together, visible in the global section. You can highlight each source individually (Source 1, Source 2, Source 3, and Source 4).

Initial Setup

For now, let's close three sources and only work with Source A.

Before diving deeper into each source, it's essential to understand that the signal flow for each synthesizer source is relatively the same:

• Volume & Tune: Basic adjustments for your sound.
• General Modulation Sources: For added dynamism in your sound.
• Filter Send: This sends your source to the filter section (Filter 1 or Filter 2).

Filters Overview

• F1: Left
• F2: Right
• If you want to send your sound to both filters, use the drop-down menu to choose your desired routing.

Effects Section

The effects section is located below the filters. Depending on your selection, here's how to direct your sound:

• Effects A: Click on any of the effects options to apply it to Effect A.

When your sound source goes through the filter section, it sends outputs to the effects, leading to the master output.

Exploring Sounds

Let's delve into the sounds available:

1. From the global section, you can select different sounds or choose a specific one.
2. You can load a Virtual Analog (VA) oscillator to start creating a new patch.

Initializing a New Patch

• Initialize Preset: Start fresh by closing unnecessary effects.
• Loading a VA is straightforward; you can select from basic and complex wave forms (e.g., classic wave table synthesis, sine, square, etc.).

Creating Sound

Let's pull up a wavetable sound:

• Effects Routing: It's currently sending to Effect 1. Adjust the center to route to both effects.

Setting Up the Filter

1. Filter Selection:

   • Set Filter 1 to a low-pass filter (12dB).
   • Set Filter 2 to a high-pass sharp filter.
   • Alternatively, switch to a band-pass filter for experimentation.

2. Drive & Resonance:

   • Adjust the drive and resonance for deeper sound shaping.

Layering Sounds

Let's explore what happens when we bring in another sound source:

• Open Source B and configure:
  • Initially, set it to send to Filter 1.

As both Source A and Source B can send to effects simultaneously, you have multiple layers of sound processing.

Filter Options

Within the filter section for Source B, you have:

• Three Different Filters:
  • Low Pass
  • Band Pass
  • High Pass
• Additional tube-like and formant-type filters add further complexity to your sound design.

Conclusion

As you can see, very quickly, you can create highly complex sounds by manipulating these individual sound sources, filters, and effects. Instead of pulling up another sound from the browser, let's continue exploring and refining the sounds we have.

Happy synthesizing!